Hi All,
I've been struggling with an application which requires a buzzer to pulse a number of pulses to correspond with different alarms (1 pulse equals area A, 2 pulses area B, etc). I think I have to buzzer output portion working (haven't tested since the last round of changes) but am definitely struggling to have the program continuously scan the fault trigger inputs and alternately pulse the buzzer if there is more than one fault trigger present (if fault #1 and fault #3 inputs are both high pulse once, pause then pulse three times repeating until the fault inputs go low). I've searched and looked at the flasher program in the downloads area (couldn't find the output driving the bulb...) to no avail.
Any help would be appreciated!
Thanks
I've been struggling with an application which requires a buzzer to pulse a number of pulses to correspond with different alarms (1 pulse equals area A, 2 pulses area B, etc). I think I have to buzzer output portion working (haven't tested since the last round of changes) but am definitely struggling to have the program continuously scan the fault trigger inputs and alternately pulse the buzzer if there is more than one fault trigger present (if fault #1 and fault #3 inputs are both high pulse once, pause then pulse three times repeating until the fault inputs go low). I've searched and looked at the flasher program in the downloads area (couldn't find the output driving the bulb...) to no avail.
Any help would be appreciated!
Thanks