Hello,
Have same FTView 6 programmed application running on PV+ Firmware 3.1 HMI and running on PV+ Firmware 5.1 HMI.
Both connect to ML1000 processor via NET-NEI module.
The PV+ Firmware 3.1 HMI connects every time to PLC
Am having lots of problems getting the Firmware 5.1 HMI to consistently connect to a similar PLC.
RSLinx is set up similiarly in both.
The Firmware 5.1 HMI at boot up gives me a Battery Low alarm and sometime during my numerous Power Off/On it says that the RSLink Server is no longer valid.
At this stage I don't know if it is HMI hardware or something else - although I am pretty sure configurations are correct.
Would appreciate any pointers.
E
Have same FTView 6 programmed application running on PV+ Firmware 3.1 HMI and running on PV+ Firmware 5.1 HMI.
Both connect to ML1000 processor via NET-NEI module.
The PV+ Firmware 3.1 HMI connects every time to PLC
Am having lots of problems getting the Firmware 5.1 HMI to consistently connect to a similar PLC.
RSLinx is set up similiarly in both.
The Firmware 5.1 HMI at boot up gives me a Battery Low alarm and sometime during my numerous Power Off/On it says that the RSLink Server is no longer valid.
At this stage I don't know if it is HMI hardware or something else - although I am pretty sure configurations are correct.
Would appreciate any pointers.
E