Hello
I have a Electro-Craft IQ-2000 PDM-30 9101-2003 servo driver.
My personality module was corrupted as the drive gives Personality Fault. The contents of the NVRAM was corrupted and I cannot access the drive using IQMaster software vers. 3.2.4. I am getting communication error.
However, I can access the drive using Terminal with ANSI emulation. I can also access the drive using Telnet in IQMaster software however since there is no ANSI emulation, the characters I get have wrong spacings. The drive responds to my commands such as HELP and also echoes them to the terminal correctly.
Is there a way to re-initalize personality module other than IQMaster software?
Is there a way I can emulate IQMaster in ANSI mode under Windows 3.1?
Could somebody give me a HEX file regarding personality file ver 9101-2003?
I have a Electro-Craft IQ-2000 PDM-30 9101-2003 servo driver.
My personality module was corrupted as the drive gives Personality Fault. The contents of the NVRAM was corrupted and I cannot access the drive using IQMaster software vers. 3.2.4. I am getting communication error.
However, I can access the drive using Terminal with ANSI emulation. I can also access the drive using Telnet in IQMaster software however since there is no ANSI emulation, the characters I get have wrong spacings. The drive responds to my commands such as HELP and also echoes them to the terminal correctly.
Is there a way to re-initalize personality module other than IQMaster software?
Is there a way I can emulate IQMaster in ANSI mode under Windows 3.1?
Could somebody give me a HEX file regarding personality file ver 9101-2003?