Issue about Mitsubishi plc receive serial communication package

Sohaboss4

Member
S
Join Date
Feb 2024
Location
Hong Kong
Posts
1
Currently,we are facing the communication go through with 422 tx+ and tx-.
Mitsubishi fx5u series is used and using command rs2.
But the package received by rs2 is not same as using the serial debug assistant .
Would it be possible to use plc to receive the raw communication package?
 

Similar Topics

C
Mitsubishi PLC connection issue.
Hi all, I new to here and new to PLC. Basically i am an software engineer.In my project i am using Mitsubishi PLC(CPUModel Q03UDV) is to...
Replies
7
Views
2,774
Ronnie Sullivan
R
R
Issue with Mitsubishi A series PLC
Hi guys, I am facing a recurring problem in a Mitsubishi make PLC installed at my facility.The PLC is of mitsubishi make, A series & has 8...
Replies
4
Views
3,102
rejoe.koshy
R
N
Mitsubishi q series plc data communication issue
hi, i am using Mitsubishi Plc Q series, we have 2 separate system both also using Q series plc, Each system also have QJ71E71-100 communication...
Replies
1
Views
2,599
nagaraj5581
N
N
Mitsubishi VFD issue
I have a problem with Mitsubishi f700 22kW [ fr-f740-00470-ec] VFD. When it arrived to our workshop, there was a short circuit between the...
Replies
6
Views
2,725
goghie
G
A
2 Mitsubishi FX5U Online Monitoring Issue
Hi all, I'm hoping one of you has encountered this problem before.. I have two Mitsubishi FX5U Processors on site, communicating over ethernet...
Replies
1
Views
1,885
parky
P
Back
Top Bottom