Good Afternoon All,
I have a 485 2 wire connection going to my bench for testing right now.
When I poll my modbus registers I have 0's.
But communication is good.
In my Kinco project under Project Database > Address Tags
I have HMI0:0 > PLC0:0 VW0 going to Address 100
I am expecting this to write the value into the mod bus register.
On the PLC side I have SlaveID.
It seems like this register is simply not populating.
Has any experienced this before?
I have a 485 2 wire connection going to my bench for testing right now.
When I poll my modbus registers I have 0's.
But communication is good.
In my Kinco project under Project Database > Address Tags
I have HMI0:0 > PLC0:0 VW0 going to Address 100
I am expecting this to write the value into the mod bus register.
On the PLC side I have SlaveID.
It seems like this register is simply not populating.
Has any experienced this before?
