Ladder Tool "The PC parameter in this project is not the default value"

[Terrence Loom]

Hello there,

i'm new to the forum and writing PLC's for that matter so pardon my lack of knowledge in this subject as i am currently studying my HND. the problem I am having is an issue in opening a saved project on melsofts fx trainer and the error reads

"Ladder Tool

The PC parameter in this project is not the default value"

I'm unsure what this means or if I have made an error when saving? the internet does not seem to have the answers

any knowledge would be greatly appreciated

kind regards

 

[gclshortt]

The manual does not show this error.
http://dl.mitsubishielectric.com/dl/fa/document/manual/plc_fx/jy997d02901/jy997d02901c.pdf
I would contact the manufacturer and see if there is a solution or update for the software.
Can you start a new project, save and load it?

Regards,
Garry
http://www.accautomation.ca