Hello
Im at a costumer and help them to solve some problems
They have a Melsec Q06H
In this program there is very difficult to read what is happning because the guy that dids this liked very much to build the hole program with Set/Reset and without comments
Looks like this al the way, i have started to make comments
So first i did change a s/r with a coil,
But my problem is that this coil is set even when it shouldnt be,
The adress was first L723, the i change it to M723
And i only write to it in one place, and read it in another place
I have rebuild all, rest latch, whitout luck..
What can it be?
Im at a costumer and help them to solve some problems
They have a Melsec Q06H
In this program there is very difficult to read what is happning because the guy that dids this liked very much to build the hole program with Set/Reset and without comments
Looks like this al the way, i have started to make comments
So first i did change a s/r with a coil,
But my problem is that this coil is set even when it shouldnt be,
The adress was first L723, the i change it to M723
And i only write to it in one place, and read it in another place
I have rebuild all, rest latch, whitout luck..
What can it be?