ROAMER_AUS
Member
Hi everyone after a long time!!!
I have afew stone cutting machines that are having VFDs upgrades. They all have various S540 models installed. Mostly FR-S540-x.xK-EC Now you notice that this model doesn't have RS485 port. So how do I extract parameters from them? It will take really long time to write down each and every one from the diplay on the paper and then put manually in again for new ones. Does anybody know if it is just the connector that they didn't put in (which I doubt) or there is whole part of communications electornic section missing inside? I have a few on the bench from different machines, but they all have RS485 port.
Thanks for the advices!!!!
I have afew stone cutting machines that are having VFDs upgrades. They all have various S540 models installed. Mostly FR-S540-x.xK-EC Now you notice that this model doesn't have RS485 port. So how do I extract parameters from them? It will take really long time to write down each and every one from the diplay on the paper and then put manually in again for new ones. Does anybody know if it is just the connector that they didn't put in (which I doubt) or there is whole part of communications electornic section missing inside? I have a few on the bench from different machines, but they all have RS485 port.
Thanks for the advices!!!!