Good day all,
I have an Allen Bradley Micrologix 1500 with an SMC stroke reading cylinder (CE1B20-75) hooked into HSC:0. It is using a phase differential sensor (CE1) made by Monosashi-Kun. I have never worked with the HSC's before so I thought I would start by building a test setup to ensure that I could read values from the cylinder, and go from there. The problem is that I have the processor in Run mode, the cylinder is connected as described in the literature, yet when I manually move the shaft back and forth, there is no change in the Accumulated value. I am looking directly at the function file, hoping to see change, but there is none. My sub-elements are set as follows -
PFN -9
UIE -1
FE -1
AS - 1
CE - 1
LPM- 1
HPM- 1
UFM- 1
OFM- 1
CD - 1
CU - 1
MOD- 6 (H)
HIP- 2147483647
LOP- -2147483648
OVF- 2147483647
UNF- -2147483647
Anything I haven't listed here is set to 0. I am looking at HSC0, which is where I have the sensor wired in.
Any thoughts as to what I'm doing wrong?
Cheers,
Mark
I have an Allen Bradley Micrologix 1500 with an SMC stroke reading cylinder (CE1B20-75) hooked into HSC:0. It is using a phase differential sensor (CE1) made by Monosashi-Kun. I have never worked with the HSC's before so I thought I would start by building a test setup to ensure that I could read values from the cylinder, and go from there. The problem is that I have the processor in Run mode, the cylinder is connected as described in the literature, yet when I manually move the shaft back and forth, there is no change in the Accumulated value. I am looking directly at the function file, hoping to see change, but there is none. My sub-elements are set as follows -
PFN -9
UIE -1
FE -1
AS - 1
CE - 1
LPM- 1
HPM- 1
UFM- 1
OFM- 1
CD - 1
CU - 1
MOD- 6 (H)
HIP- 2147483647
LOP- -2147483648
OVF- 2147483647
UNF- -2147483647
Anything I haven't listed here is set to 0. I am looking at HSC0, which is where I have the sensor wired in.
Any thoughts as to what I'm doing wrong?
Cheers,
Mark