JohnnyQuanex
Lifetime Supporting Member
Hi again folks,
In advance, thank you for your extremely valuable input... LOL
I'm trying to use a MCD in conjunction with an MAM to vary the move speed...
When it cycles it will move to the specified position, but then won't (the MAM that is) go in .PC status. (Therefore, the logic won't move to the next state of my machine.)
I've confirmed my logic works by doing away with the MCD and putting a static speed value into the MAM. It works fine.
See snips of ladder for reference...
Any help?
Thanks,
John
In advance, thank you for your extremely valuable input... LOL
I'm trying to use a MCD in conjunction with an MAM to vary the move speed...
When it cycles it will move to the specified position, but then won't (the MAM that is) go in .PC status. (Therefore, the logic won't move to the next state of my machine.)
I've confirmed my logic works by doing away with the MCD and putting a static speed value into the MAM. It works fine.
See snips of ladder for reference...
Any help?
Thanks,
John