rdrast has said the same as one of my previous posts, I agree just make each bit in the N register 0-7 equal the relevant output i.e. 8-15 (assuming that the ML has the ability to use discrete bits from an integer file I have not installed my licences so can't check at the moment).
Move instruction
- Thread starter chuckiebuckets
- Start date
Similar Topics
Hi All,
I am using 2 MOVE instructions in Studio 5000 logic designer to move 2 different values in the same destination tag N7[190]. Two...
Hi
I'm working with twdlmda20drt and i was wondering if there is a move instruction in twidosuite cause i cant find it and i may need in the...
Hi all
I currently have a system where data is scanned into a system and in the fc is a move instruction which I move a '00' on the input and...
Hey I'm new to rs logic 5000 I have the basics but I'm getting confused with this mvm instruction. Can anybody bum it down for pls
Thanx in advance
Hello everyone
Im using SoMachine Basic V1.5, the PLC is a TM221CE16R with analog inputs, I also have a TM3A2Q (analog out)
I have everything...