I have RS232 9 pins (pin to pin connection) connecting my laptop to panel view 300 with serial number : 2711-K3A5L1. I am using panelbuilder 32 sofware using the terminal setup for 2711-K3A17 FRN4.10-4.XX, protocol DF1
I tried communicating using both panelbuider 32 software and RSlinx softwere using RS232 DF1 devices
When using RSlinx I use the settings:
Comm port: COMM 1
Device: SLC-CH0/Micro/PanelView
PARITY: None
Station Number: 01
Errror Checking: BCC
Stop Bit: 1
Protocol: Full Duplex
When I hit Auto-Confiqure, I could see it testing BCC and then testing CRC error checking and then display the error,
"Unable to verify settings due to packet timeout, check all cables and configuration and try again"
I tried communicating using both panelbuider 32 software and RSlinx softwere using RS232 DF1 devices
When using RSlinx I use the settings:
Comm port: COMM 1
Device: SLC-CH0/Micro/PanelView
PARITY: None
Station Number: 01
Errror Checking: BCC
Stop Bit: 1
Protocol: Full Duplex
When I hit Auto-Confiqure, I could see it testing BCC and then testing CRC error checking and then display the error,
"Unable to verify settings due to packet timeout, check all cables and configuration and try again"