Hey guys
Hardware:
1769-L32E CPU
1769-PA4 Power Supply
1769-IA16 Input Card
1769-OW16 Output Card
1769-IF4XOF2 Analog Card
I just built a PLC workstation. It's composed of eight toggle switches, and four NC and four NO pushbuttons. It also has 16 LED pilot lights for output simulation. I have a pot for an analog input.
I am not familiar with setting up communications. I have my 1769-L32E controller installation instructions. Here is the PDF link... http://literature.rockwellautomation.com/idc/groups/literature/documents/in/1769-in020_-en-p.pdf
Go to page 19 on the PDF file. My question is, how do you assign an IP address??? Im sorry for my ignorance but I am not experienced with communication setup.
Is it asking the IP on the controller (which I assume) or the PC's IP address? I just need details on this. I also need to enter the ethernet mask and gateway. I have no idea where to find these addresses.
I hope I have made myself clear and thank you all for your help!
Hardware:
1769-L32E CPU
1769-PA4 Power Supply
1769-IA16 Input Card
1769-OW16 Output Card
1769-IF4XOF2 Analog Card
I just built a PLC workstation. It's composed of eight toggle switches, and four NC and four NO pushbuttons. It also has 16 LED pilot lights for output simulation. I have a pot for an analog input.
I am not familiar with setting up communications. I have my 1769-L32E controller installation instructions. Here is the PDF link... http://literature.rockwellautomation.com/idc/groups/literature/documents/in/1769-in020_-en-p.pdf
Go to page 19 on the PDF file. My question is, how do you assign an IP address??? Im sorry for my ignorance but I am not experienced with communication setup.
Is it asking the IP on the controller (which I assume) or the PC's IP address? I just need details on this. I also need to enter the ethernet mask and gateway. I have no idea where to find these addresses.
I hope I have made myself clear and thank you all for your help!