kirk seiter
Member
I have a conveyor with 80 zones. Each has a timer. Since each zone timer serves the same function, I would like to be able to adjust the preset time globally. Any suggestions?
Hakutsuru said:...I cant think of a way to do that in AB...
The moral of that thread was why? Why do you want to just because you can?Hakutsuru said:Yeah, that doesn't really address the question at hand.
Hakutsuru said:HD_Coop, you know you can use a for/next loop too, right? At least, you can in a PLC5, I assume its still there in the later processors. Also, in that bit of program, I can't figure out how the NEQs ever evaluate to true? When do N7:2 and N7:3 get unequal?
-jeff
Hakutsuru said:GIT, (I may call you git, right?)
Hakutsuru said:Seriously, whether he should be doing it is only half the question here. Its still a worthy exercise even if he has no good reason for it. And BTW, while I don't know conveyors, I can think of plenty of good reasons to be able to change a group of timers with just one setpoint.
No I don't think he is, I am just an *** and enjoy a good Thursday afternoon debate and you looked like you would fall into my trapHakutsuru said:I mean, unless you think he is a student trying to sneak a homework assignment by us and you are trying to ferret him out. In which case, I apoligize if I in any way dampened your fun.
geniusintraining said:No I don't think he is, I am just an *** and enjoy a good Thursday afternoon debate and you looked like you would fall into my trap