Hi There,
I've started a new program using CX programmer.
Single input, single coil on a single rung. When running simulator in monitor mode I cannot get the coil to turn green unless I 'set on'. Using the input NO contact I get green either side of the coil but no the actual coil itself.
Have set operating mode to monitor, completely restarted CX programmer and created a whole new program with only the below ladder.
Any help appreciated.
I've started a new program using CX programmer.
Single input, single coil on a single rung. When running simulator in monitor mode I cannot get the coil to turn green unless I 'set on'. Using the input NO contact I get green either side of the coil but no the actual coil itself.
Have set operating mode to monitor, completely restarted CX programmer and created a whole new program with only the below ladder.
Any help appreciated.
0.04 W100.0
------| |-------( )-------|