bayeibrahima
Member
Hello to all
An omron NS5-SQ10-V2 is connected to CP1L plc.
An output of the plc was not responding although the corresponding led output is toggling when i send command (manual) through the NS panel
I open the plc to see if there's not a fuse which would be probably blown,but all seem to be ok.I assemble the plc and mounted it in the cabinet and tried again the same operations (through the NS screen) and the default remained
Three days after, I came back in order to connect with plc and computer to follow what is happening online.
When I power ON the cabinet, i was surprised to see that the NS screen after start up process displays the prompt " CONNECTING" and stop there.
I tighten DB9 connectors in both side (plc and NS screen) and power again, but I always have the same message "CONNECTING"
Can someone help me please and tell me what is wrong?
Hope to read you soon
Best regards
An omron NS5-SQ10-V2 is connected to CP1L plc.
An output of the plc was not responding although the corresponding led output is toggling when i send command (manual) through the NS panel
I open the plc to see if there's not a fuse which would be probably blown,but all seem to be ok.I assemble the plc and mounted it in the cabinet and tried again the same operations (through the NS screen) and the default remained
Three days after, I came back in order to connect with plc and computer to follow what is happening online.
When I power ON the cabinet, i was surprised to see that the NS screen after start up process displays the prompt " CONNECTING" and stop there.
I tighten DB9 connectors in both side (plc and NS screen) and power again, but I always have the same message "CONNECTING"
Can someone help me please and tell me what is wrong?
Hope to read you soon
Best regards