Hi folks, I have a bank of 9 digital readout units. They plug together to make up a 9 digit readout. Each unit is one digit. The kicker is that the second digit has a decimal point. I can't find out how to move it to the 3rd digit. These are Omron A7E-AG21H-DR. They each run to a central digital control card. Also, they plug together which ends up at an end plate. I think the decimal is moved by changing the end plate but can't find any scamatics on this. Anyone ever saw one of these before? I understand if you hadn't. They came from Japan and can't find any paperwork with them. Thanks in advance for any help.
Omron Digital Readouts
- Thread starter ironsj
- Start date
gtsuport
Member
Looks like this part was on its way out in 1994.
Have you tried Omron support? 800-556-6766
They might be able to get you a data sheet.
Good Luck.
Have you tried Omron support? 800-556-6766
They might be able to get you a data sheet.
Good Luck.
Similar Topics
Hello,
We have this SCADA system Vijeo Citect 7.2 Windows 7.
PLC: OMRON C200HG
Protocol
UNITY MODNET30
OMRON OMRON
OFSVIJEO MODCELL
All...
Good morning everyone I’m currently working on a omron device net and have a nord drive that fell off the network. I have limit knowledge in...
I've come across a system running omeron cx-programmer version 9.42. Am I going to need to find a legacy version of the software to edit and...
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...