geniusintraining
Lifetime Supporting Member + Moderator
This is similar to what I have done in the past and have the need to do again, it works ok, just not great
I think the pic shows a lot, anyone have a better concept? the new one is going to be short 3m travel aprox, I have them up to 12m the belt is the issue with that length, I have to have it banjo tight.
I have Baldor, SEW and Danfoss drives and other suggestion on drives?
I think I will be getting some from another plant, if so they will have motors but no drives, they also have small servos on the suction cups to run them in and out, my others are manual, but this means it could be up to six axis EDIT: the six come from 2 heads one to pick and the other to place 3axis per head
Thanks
In the second pic you can see the idler, must of been off in the first
I think the pic shows a lot, anyone have a better concept? the new one is going to be short 3m travel aprox, I have them up to 12m the belt is the issue with that length, I have to have it banjo tight.
I have Baldor, SEW and Danfoss drives and other suggestion on drives?
I think I will be getting some from another plant, if so they will have motors but no drives, they also have small servos on the suction cups to run them in and out, my others are manual, but this means it could be up to six axis EDIT: the six come from 2 heads one to pick and the other to place 3axis per head
Thanks
In the second pic you can see the idler, must of been off in the first
Last edited: