eForce Member E Join Date Dec 2007 Location Ontario Posts 12 Dec 2, 2007 #1 Hi, I have 2 FP2 processors on Nano Racks with ET1 Lan Units installed. Can anyone help me get these to communicate. All I want to do is have one PLC read 3 inputs from the other PLC.
Hi, I have 2 FP2 processors on Nano Racks with ET1 Lan Units installed. Can anyone help me get these to communicate. All I want to do is have one PLC read 3 inputs from the other PLC.
Arlie Member A Join Date Jun 2007 Location Ellenville,NY Posts 83 Dec 2, 2007 #2 heya, what you can do is use 3 outputs from the one plc as inputs to the other , let me know what it is you are trying to do and I will try to help you out, what software are you using FPWINPRO or GR
heya, what you can do is use 3 outputs from the one plc as inputs to the other , let me know what it is you are trying to do and I will try to help you out, what software are you using FPWINPRO or GR
eForce Member OP E Join Date Dec 2007 Location Ontario Posts 12 Dec 2, 2007 #3 Oh normally I would but the PLC's are on opposite sides of the factory and connected through an Ethernet cable. I'm using FPWin Pro
Oh normally I would but the PLC's are on opposite sides of the factory and connected through an Ethernet cable. I'm using FPWin Pro
Arlie Member A Join Date Jun 2007 Location Ellenville,NY Posts 83 Dec 3, 2007 #4 give me a few and I will see what I can come up with.
eForce Member OP E Join Date Dec 2007 Location Ontario Posts 12 Dec 3, 2007 #5 Anything you can come up with would be appreciated. Thanks in advance.
Arlie Member A Join Date Jun 2007 Location Ellenville,NY Posts 83 Dec 3, 2007 #6 ok have you called panasonic tech support?? I think they can help you alot better than I if you need there numnber let me know I will give it to you
ok have you called panasonic tech support?? I think they can help you alot better than I if you need there numnber let me know I will give it to you
eForce Member OP E Join Date Dec 2007 Location Ontario Posts 12 Dec 3, 2007 #7 I have actually, they just sent me some ample programs but they are in FPWinGR and I have FPWinPro.
Arlie Member A Join Date Jun 2007 Location Ellenville,NY Posts 83 Dec 4, 2007 #8 import them into PRO, just open pro first, create an empty project, then import it. just use direct addressing
import them into PRO, just open pro first, create an empty project, then import it. just use direct addressing
eForce Member OP E Join Date Dec 2007 Location Ontario Posts 12 Dec 4, 2007 #9 well I'll be!!!! Thanks bud. I'll have a look here and see what I can learn
Arlie Member A Join Date Jun 2007 Location Ellenville,NY Posts 83 Dec 4, 2007 #10 Hey no problem, hope you get it, glad I could help for once