I have a customer that has an Panelview 1200 that has failed with no back up. It is connected to a PLC5/40. I don't have a problem recreating the screens in Factory Talk View. I used Panelview Plus HMI's several years ago with the 2711p-RN6 comm card with success but from what I have read it requires firmware 5.10 or older.
My question is would anyone recommend using a serial connection to CH0 on the PLC?
Or should I install a older terminal with firmware 5.10 and use the DH+/RIO comm card?
This machine is going to be around a while.
Thanks,
Doug
My question is would anyone recommend using a serial connection to CH0 on the PLC?
Or should I install a older terminal with firmware 5.10 and use the DH+/RIO comm card?
This machine is going to be around a while.
Thanks,
Doug