Hi,
We've a customer using PLC5/25, I notice there are 3 comm ports.
One 9 pin female DH+ programming port (1784-PCMK)
One 3 pin DH+ comm port
One 3 pin RIO comm port.
The RIO comm port is fully utilize (max 8 nodes).
We need to get a small PV for the system, can we use the 3 pin DH+
comm port for comm between the PLC 5/25 & the new PanelView? If not
mistaken the 3 pin DH+ comm port is shared with the 9 pin female
programming port, if the 3 pin is connected to the PV, can we still
access the 9 pin female port for programming purpose at the same time?
--
Thanks.
We've a customer using PLC5/25, I notice there are 3 comm ports.
One 9 pin female DH+ programming port (1784-PCMK)
One 3 pin DH+ comm port
One 3 pin RIO comm port.
The RIO comm port is fully utilize (max 8 nodes).
We need to get a small PV for the system, can we use the 3 pin DH+
comm port for comm between the PLC 5/25 & the new PanelView? If not
mistaken the 3 pin DH+ comm port is shared with the 9 pin female
programming port, if the 3 pin is connected to the PV, can we still
access the 9 pin female port for programming purpose at the same time?
--
Thanks.