Hello Everyone,
I am trying to set up messaging instructions between these two PLC.
PLC 1 = 1769L32E Compact Logix 5332E Controller V17 of Logix 5000
PLC 2 = 5069-L320ERM Controller 5380 Controller V31 of Studio 5000. It is set up as Dual IP. A1 for Enterprise and A2 for Local IO
Based on this article I tried everything for CIP Data table read setting.
Tried all 4 options. 1, IP address | 2, IP Address upto 4
https://www.plctalk.net/qanda/archi...rst chassis (the clx backplane always uses 1)
Still I could not communicate and I get the ER bit on the message instruction on.
Based on this
https://literature.rockwellautomation.com/idc/groups/literature/documents/um/5069-um001_-en-p.pdf
I even tried CIP Generic message type as well. I would really appreciate your help
I am trying to set up messaging instructions between these two PLC.
PLC 1 = 1769L32E Compact Logix 5332E Controller V17 of Logix 5000
PLC 2 = 5069-L320ERM Controller 5380 Controller V31 of Studio 5000. It is set up as Dual IP. A1 for Enterprise and A2 for Local IO
Based on this article I tried everything for CIP Data table read setting.
Tried all 4 options. 1, IP address | 2, IP Address upto 4
https://www.plctalk.net/qanda/archi...rst chassis (the clx backplane always uses 1)
Still I could not communicate and I get the ER bit on the message instruction on.
Based on this
https://literature.rockwellautomation.com/idc/groups/literature/documents/um/5069-um001_-en-p.pdf
I even tried CIP Generic message type as well. I would really appreciate your help