bakerboy_99ca
Member
good evening everyone. I am fairly new here but I am finding I love this place alot..excellent questions and a whole lot of people helping. I am about 6 months in a new job of Robotic Tech, and I have been going through all the old programming of the machinery (Allen Bradley SLC 500,1,2,3,4, Micrologix and Omrom) and cleaning them up ALOT! I beleive a good plc progrmmer is invaluable to a company and most people cannot appreciate all the effort that is put forth to compile a descent ladder logic program that will catch everyone else's screwups!
I am not reconized as a skilled tradesman but the knowledge i posses should be just as important to my company as a millwright, tool and die or machinist. I admire all of you because I also sit here hour after hour programming logic into a computer only to have most of my work go unappriciated and taken for granted.
I cannot wait to get stuck so I can post a question.
Anyone in to rpc code on built in plc in nachi robots?
I am not reconized as a skilled tradesman but the knowledge i posses should be just as important to my company as a millwright, tool and die or machinist. I admire all of you because I also sit here hour after hour programming logic into a computer only to have most of my work go unappriciated and taken for granted.
I cannot wait to get stuck so I can post a question.
Anyone in to rpc code on built in plc in nachi robots?