PLC to DNC Server

[consol]

Hi,
I need to request data from a DNC server from a CompactLogix PLC.
Does anybody have any experience of this?
Thanks,
consol

 

[wassim.daoud]

you should use OPC for that. Use this OPC Server for you CompactLogix PLC:
http://www.matrikonopc.com/opc-drivers/299/base-driver-details.aspx

For your DNC, use the Generic OPC Server to create your protocol:
http://www.matrikonopc.com/products/opc-drivers/opc-genie.aspx

To connect both systems, use OPC Data Manager. It will bridge your data and establish a bidirectional communication.
http://www.matrikonopc.com/products/opc-data-management/opc-data-manager.aspx

Hope this was helpful
Wassim Daoud
Global Solutions Architect
www.MatrikonOPC.com

 

[consol]

Thanks Wassim,
It's an option.
Will the three servers run on the DNC server?

Tim

 

[wassim.daoud]

If your DNC Server is Windows base, then you should be good to go

 

[consol]

Another scenario,
Can the OPC servers reside on a separate PC? Like a HMI? (Wonderware)

Thanks,

 

[wassim.daoud]

Absolutely they can be installed on a separate PC. As long as there are communication links between the OPC servers and your DNC Server and CompactLogix PLC (which i am gonna assume that you already have in place if you have your WW HMI connected to both DNC Server and CompactLogix PLC).