Anyone know how this would look in ladder programing?
using a PD coil (using a Control Relay Bit, C100 for instance) being activated by a n.c. (normally closed) contact of the Output Active Bit for the output. The use the C100 Control Relay to start the next profile.
(The profile is just for a motor.)
Thanks
using a PD coil (using a Control Relay Bit, C100 for instance) being activated by a n.c. (normally closed) contact of the Output Active Bit for the output. The use the C100 Control Relay to start the next profile.
(The profile is just for a motor.)
Thanks