JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
PVPlus alarm banner probs.
No matter how much squashing & squeezing I subject the alarm banner to, it still resolutely presents itself in the middle of the screen. I've attached a screenshot of my attempt to crop it. I've checked its position and it shows as being 0,0 in properties. Where's the magic button? Thanks, anyone.
X,y,0,0
D'oh! (And thank you). I was focussed on the banner position. Completely missed the change in options for "on top" screens.
So I've got an issue I have yet to figure out. I have a PVPlus standard HMI runtime v12. I've gone into the system and set the date and time and...
Hello,
Using FT for PVPlus Compact 400/600 (320x240)
I insert a button to acknowledge larms in my larm screen. When i press this button the...
Hello, I want to make touchscreen push buttons invisible based on certain conditions. When these conditions are true, these buttons will become...
Hello all. Sure hope someone can help with this. I have a system down because it is dependent upon its PV1000 and operator inputs to run it. I had...
I'm looking to use a second monitor as a data display for a customer. I know the FTVP is available but would like to actually duplicate the...