jdf
Member
Hi All
Is it possible to read a multiple called FB with live data from the point of call in Step 5 as can be done in Step 7.
In Step 7 if you want to look at data in a multiple called FB or FC you would do the following.
From task bar- debug – operation – then check test operation in the pop up box and click ok – from the task bar click on the down load icon – in the pop up box click on NO – then right click on the FC or FB and highlight block call and click on the option monitor with call-up path. This will open up the FB, FC on line with only the data for that call shown.
Is there any procedure in Step 5 for doing the same as above.
Kind Regards
Jon
Is it possible to read a multiple called FB with live data from the point of call in Step 5 as can be done in Step 7.
In Step 7 if you want to look at data in a multiple called FB or FC you would do the following.
From task bar- debug – operation – then check test operation in the pop up box and click ok – from the task bar click on the down load icon – in the pop up box click on NO – then right click on the FC or FB and highlight block call and click on the option monitor with call-up path. This will open up the FB, FC on line with only the data for that call shown.
Is there any procedure in Step 5 for doing the same as above.
Kind Regards
Jon