Hi Guys
I've got some application where i need a very high accurate speed measurement for a line
There isn't enough information here. What is "very high accuracy" to one person is just a rough estimate to another.
and the encoder cann't achieve such accuracy due to mechanical issues...
The only scenario that comes to my mind this early in the morning is that the encoder is driven by the product moving through the machine, and not driven by the machine itself. And you want to measure the speed of the line with no product.
Can i measure the speed of line according to the VFD connected to the motors pulling the line or not? I've got a D/A module controlling the inverter i just need to know if it is possible? and more information about its accuracy?
Thanks
Well maybe. Some of the things that are important are:
1. Type of feedback the inverter drive has from the motor. This ranges from none to sensorless vector to encoder (presuming we are not talking about the same encoder that has the "mechanical issues").
2. Is there any way the motor can have any slip between the motor and the machine? This would include clutches, V belts hydraulic drive ect.
3. Then there is the inverter itself you have not stated what inverter you are using. The finest inverter I have used for speed control is a ABB ACS800 with encoder feedback. The accuracy I'm able to achieve with the ACS800 is: motor at 1750 RPM = 650 FPM line speed, .125" error in 20 feet of line travel.
4. The D/A module can also be a source of error. The worst error I have ever seen is on a smart relay analog setup. The resolution was only 4bit (16 points) between 0 volts and 10 volts. In the application I mentioned previously all control was digital between drives and controller.
Edit: I see Robertme responded before I did and my typing must be very slow judging by the post times!