Hi again,
I know this probably isn't the forum for this, in fact I have found one that specifies in VFDs, but as I just registered, I can't start a thread.
Anyway, this is as I said is a Reliance SP120, for a 5HP motor.
It was in working order when I took it out, probably around 2 years ago, and I just stuck in on a shelf.
What I want to use it for now, is to make a motor run 80Hz (speed pot on the unit itself) and start with a two wire set up.
I've tried to figure out the programming, but I'm not sure if I even have the control wiring correct.
(I have the switch between terminals 1 and P24)
The PDF manual for it can be found here (Rockwell website).
Thanks
I know this probably isn't the forum for this, in fact I have found one that specifies in VFDs, but as I just registered, I can't start a thread.
Anyway, this is as I said is a Reliance SP120, for a 5HP motor.
It was in working order when I took it out, probably around 2 years ago, and I just stuck in on a shelf.
What I want to use it for now, is to make a motor run 80Hz (speed pot on the unit itself) and start with a two wire set up.
I've tried to figure out the programming, but I'm not sure if I even have the control wiring correct.
(I have the switch between terminals 1 and P24)
The PDF manual for it can be found here (Rockwell website).
Thanks