Hi everyone, I want to thank the kind folks who have been helping me so far.
I am working on a practice lab, I'll post the picture of my ladder logic first then explain where I am stuck.
I am supposed to have one start button
one stop button.
holding circuit
one motor comes on 10 seconds after PB is pushed and remains on for 7 seconds.
1 green pilot for the motor on and only when it is on.
1 red pilot light always on when the motor and/or the GPL is not on.
if the inputs to the timer go false or if there is a loss of power the timer must keeps it's accumulated value.
once a full cycle is complete the timer must reset automatically.
Cycle stops automatically after the motor stops.
On my simulator I have satisfied all the requirements except after the second Timer starts when I push the stop button the process stops but only if I keep the button pushed in, I need the process to stop and stay false until the start button begins the cycle.
Any sugestions are appreciated.
Thanks again.
I am working on a practice lab, I'll post the picture of my ladder logic first then explain where I am stuck.
I am supposed to have one start button
one stop button.
holding circuit
one motor comes on 10 seconds after PB is pushed and remains on for 7 seconds.
1 green pilot for the motor on and only when it is on.
1 red pilot light always on when the motor and/or the GPL is not on.
if the inputs to the timer go false or if there is a loss of power the timer must keeps it's accumulated value.
once a full cycle is complete the timer must reset automatically.
Cycle stops automatically after the motor stops.
On my simulator I have satisfied all the requirements except after the second Timer starts when I push the stop button the process stops but only if I keep the button pushed in, I need the process to stop and stay false until the start button begins the cycle.
Any sugestions are appreciated.
Thanks again.