Hello, PLCS.net guys.
Currently I'm making the safety communication on 1756-DNB to DX200 Yaskawa contoller.
I made the setting and assigned the SNN to DX-200, also I didn't use configuration signature same as the manual.
On RSLogix, the module and also DX-200 itself don't generate the ERROR and it look running normally.
But 1756-DNB keeps generating Alarm#83.
The alarm shows the device is assigned to other scanner or reply some error from the device.
But DX-200 doesn't look generating error, also I checked something depending the manual.
But I'm not sure what's wrong.
Could you give me some advices?
Thank yhou.
Currently I'm making the safety communication on 1756-DNB to DX200 Yaskawa contoller.
I made the setting and assigned the SNN to DX-200, also I didn't use configuration signature same as the manual.
On RSLogix, the module and also DX-200 itself don't generate the ERROR and it look running normally.
But 1756-DNB keeps generating Alarm#83.
The alarm shows the device is assigned to other scanner or reply some error from the device.
But DX-200 doesn't look generating error, also I checked something depending the manual.
But I'm not sure what's wrong.
Could you give me some advices?
Thank yhou.