Austin1985
Member
Hello,
Question:
(Temp is whats being controlled here by 3 fans)
Using a PID; can I set my output (CV) to be 100% at a specific input (PV)? In other words; the set point is 80, and (PV) is at 80 (not pushing hard / trying to climb) then the (CV) would run at set min. But then (PV) starts to climb, I want to make sure the (CV) will be at 100% when (PV) hits 81.5.
If (CV) is at 100% for X time, I will start a second fan to help bring down the temp back to 80. But I don't want to get hotter than 81.5 for very long.
Thanks
Question:
(Temp is whats being controlled here by 3 fans)
Using a PID; can I set my output (CV) to be 100% at a specific input (PV)? In other words; the set point is 80, and (PV) is at 80 (not pushing hard / trying to climb) then the (CV) would run at set min. But then (PV) starts to climb, I want to make sure the (CV) will be at 100% when (PV) hits 81.5.
If (CV) is at 100% for X time, I will start a second fan to help bring down the temp back to 80. But I don't want to get hotter than 81.5 for very long.
Thanks