The CP143 (If I remember correctly needs either an Eprom or Ram card the configuration is downloaded to it.
Then you call the various blocks to transfer data. I think somewhere I have an old S5 file of a project I did in the 90's , but now I do not have either S5 or Com software but if it helps perhaps I could find it & send it to you, it is for a 150 or 155 processor though, but I very much doubt I have the 143 file.
although I seem to remember upgrading it to a 115(945) processor, it is quite a big program but also uses com525 as well.
Then you call the various blocks to transfer data. I think somewhere I have an old S5 file of a project I did in the 90's , but now I do not have either S5 or Com software but if it helps perhaps I could find it & send it to you, it is for a 150 or 155 processor though, but I very much doubt I have the 143 file.
although I seem to remember upgrading it to a 115(945) processor, it is quite a big program but also uses com525 as well.
