KEN_KACEL
Member
I need to find out what is needed to talk to a Siemens 934. There are 4 in an injection molding facility and we need to know what it might take to support this equipment.
Siemens 934 on a Husky Press
- Thread starter KEN_KACEL
- Start date
silva.foxx
Member
Siemens S5-115U CPU943... yes?
If so Siemens STEP 5 software (or IBH Softec, or Pantek Quadriga)
http://www.ibhsoftec-sps.de/english/Selection_S5_S7.htm
Serial/USB-TTY adaptor lead
perhaps... http://www.plctrainer.net/PLCProgrammingCables.htm
If you meant 934 then I'm at a loss.
If so Siemens STEP 5 software (or IBH Softec, or Pantek Quadriga)
http://www.ibhsoftec-sps.de/english/Selection_S5_S7.htm
Serial/USB-TTY adaptor lead
perhaps... http://www.plctrainer.net/PLCProgrammingCables.htm
If you meant 934 then I'm at a loss.
Last edited:
Similar Topics
Hello everyone, I've had this issue for the last 2 days where I try to assign the profisafe address to an IO block (6ES7 146-6FF00-0AB0) but when...
Hello, good morning, I have been having two problems with the Tia Portal software.
The first is that I have installed it on my computer and...
Hello to all,
I'm just starting with using CodeSys. Immediately, I have noticed that Codesys doesn't use data blocks like for example S7 does...
Hi,
I'm setting up a modbus master on an S7-300. It seems to work in OB1 but not when I use it in OB35. Does anyone have any ideas why?
Could...
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
