I have an installation with an S7-414 and a CP441-1 connected to a serial modem, i've been trying to get data transmitted to a remote system. however every time i try to dial out with the modem, the modem hangs up as soon as it detects a dialtone. I know i'm using the right SFC/SFB (BSEND and BRCV an V24_STAT en V24_SET) so it must have something to do with the signal handling of the modem but i can't figure out what. So is ther eanybody who's done that before and can tell me what the problem area's are
Siemens S7 communcation with Cp441 and modem
- Thread starter noyb
- Start date
Mike Williams
Member
test
Similar Topics
Hello everyone, I've had this issue for the last 2 days where I try to assign the profisafe address to an IO block (6ES7 146-6FF00-0AB0) but when...
Hello, good morning, I have been having two problems with the Tia Portal software.
The first is that I have installed it on my computer and...
Hello to all,
I'm just starting with using CodeSys. Immediately, I have noticed that Codesys doesn't use data blocks like for example S7 does...
Hi,
I'm setting up a modbus master on an S7-300. It seems to work in OB1 but not when I use it in OB35. Does anyone have any ideas why?
Could...
The past week we received a new piece of equipment from Germany which utilizes siemens controls. Typically in our company we use A.B. controls for...
