hi
i need help to finish my start up for simoreg drive 6ra24 1200 amp
we use it for 450 kw motor for cement factory. i face many problems
1-no one of optimization run so i insert it manually.
2- when it is start with zero set point i get output flacuate (-1 to 1 volt) .
3- when the motor is not loaded i can rotate it to max speed but it did not stop when reference is zero(very slow speed) when the motor is loaded it can not rotate even i reache 700 amp take in mind no mechanical problems as motor rotate on other drive.
thanks.
i need help to finish my start up for simoreg drive 6ra24 1200 amp
we use it for 450 kw motor for cement factory. i face many problems
1-no one of optimization run so i insert it manually.
2- when it is start with zero set point i get output flacuate (-1 to 1 volt) .
3- when the motor is not loaded i can rotate it to max speed but it did not stop when reference is zero(very slow speed) when the motor is loaded it can not rotate even i reache 700 amp take in mind no mechanical problems as motor rotate on other drive.
thanks.
Last edited: