The Plc Kid
Member
I am adding some BTW / BTR instructions to a slc 5/04 processor and i have 2 questions.
1.0 Following the attached example i am trying to determine which of these methods i need to use if any. It willbe bi-directional reads and writes about 14 each.
2.0 I am trying to understand correctly if i should interlock when they trigger and why? These will all need to continious but i have heard that you do not want to fire them all at once.Should i interlock a read and write by the example and then interock this set to my other sets?
How could i accomplish this. I am stuck on how to do this properly.
1.0 Following the attached example i am trying to determine which of these methods i need to use if any. It willbe bi-directional reads and writes about 14 each.
2.0 I am trying to understand correctly if i should interlock when they trigger and why? These will all need to continious but i have heard that you do not want to fire them all at once.Should i interlock a read and write by the example and then interock this set to my other sets?
How could i accomplish this. I am stuck on how to do this properly.