ubay
Guest
U
i'm new in using PLC...
first time i used it, there is no problem in it. Then suddenly red cross showed up. so i check on the help-online ----> and the help said to remove, so i removed it. but after that, i can't detect again my PLC.
i'm using SLC5/05 1747-L552 (modular type), and communicate with PC with RS232..
the problem is that my PC can't detect the PLC but when i saw through the driver diagnostic, there are packets sent and reply in a good way, but i still can't detect my PLC. Then here are some things that i have done :
- i check the power ----> is connected
- i check the serial RS232 ----> is connected
- i configure the driver -----> AB-DF1 Serial
- i uninstall the operating system and all the software -----> didn't worked out
- because i'm also using womderware as the MMI, i uninstall it also, but still didn't work out
- i change the communication using ethernet -----> still can't work out, it found the node but can't detect the device (the device slc5/05 not recognized)
anybody can help me with this problems...
btw. i'm using only RSLinx Lite..and not using any modul as an addition such as PIC-driver or else instead using direct connections
now, i'm in desperate conditions...
i eager to hear from forums as soon as possible, mail me at
- [email protected]
- [email protected]
best regards...
first time i used it, there is no problem in it. Then suddenly red cross showed up. so i check on the help-online ----> and the help said to remove, so i removed it. but after that, i can't detect again my PLC.
i'm using SLC5/05 1747-L552 (modular type), and communicate with PC with RS232..
the problem is that my PC can't detect the PLC but when i saw through the driver diagnostic, there are packets sent and reply in a good way, but i still can't detect my PLC. Then here are some things that i have done :
- i check the power ----> is connected
- i check the serial RS232 ----> is connected
- i configure the driver -----> AB-DF1 Serial
- i uninstall the operating system and all the software -----> didn't worked out
- because i'm also using womderware as the MMI, i uninstall it also, but still didn't work out
- i change the communication using ethernet -----> still can't work out, it found the node but can't detect the device (the device slc5/05 not recognized)
anybody can help me with this problems...
btw. i'm using only RSLinx Lite..and not using any modul as an addition such as PIC-driver or else instead using direct connections
now, i'm in desperate conditions...
i eager to hear from forums as soon as possible, mail me at
- [email protected]
- [email protected]
best regards...