Hmm, I think it should be compatible. Can you share your system info using this guide? https://support.microsoft.com/en-us/kb/255979
Step 7 communication port missing
- Thread starter fons04
- Start date
Hmm, I think it should be compatible. Can you share your system info using this guide? https://support.microsoft.com/en-us/kb/255979
Can you tell me what you want to know in device manager? I don't have Generic, i have windows 7
You can print it out as a .XPS or .PDF, it doesn't matter.
I want to know what driver you have installed for your COM device, the VID/PID and if it's working properly.
Similar Topics
I am trying to access PLC 317 via Ethernet but not success so far... don't know what wrong m doing,
it shows connected but no ping.
please see...
I need to set up ethernet communication between a Beckhoff CX1020 and a Simatic PLC (Most likely a 315-2DP). Is there anyone with experience in...
Need a communication ethernet block for Step 7 (WinAC & LC)with a Bosch (torque runner) LT303/4/5. Right now is a pain going through VB...
Has anyone ever set up communications with a Red Lion EPAX-6 Digit Display via Profibus? The hardware configuration was no problem, but I have...
Does anyone knows where to find information about: how to connect a serial 9 pins port with a S5-95u PLC ?
I want to make the cable myself and I...
