Hunterseeker
Member
Good Morning Folks,
I'm having an issue with a triconex tri-gp. After 24-48 hours of runtime, I lose my SCADA connection to it, which I correct by power cycling the switch. Looking into the switch, I see that the ports are reading half-duplex from the CIM card, while the rest of the network is full-duplex. I suspect this may be the cause of the dropout, though I am open to any other suggestions!
On the CIM card though, I have it set to full-duplex.
Has anyone ran into this issue?
All help is very appreciated, many thanks.
I'm having an issue with a triconex tri-gp. After 24-48 hours of runtime, I lose my SCADA connection to it, which I correct by power cycling the switch. Looking into the switch, I see that the ports are reading half-duplex from the CIM card, while the rest of the network is full-duplex. I suspect this may be the cause of the dropout, though I am open to any other suggestions!
On the CIM card though, I have it set to full-duplex.
Has anyone ran into this issue?
All help is very appreciated, many thanks.