stevez
Member
- Join Date
- May 2003
- Posts
- 90
I had a fault on a machine in a Clean (sterile)room.
The control cabinet and PLC are in the clean room.I had to wrap the laptop in 2 plastic bags .It then was cleaned with alcohol and left for 10 minutes in a pass through chamber.
Problems -the laptop heated up ,its not easy to see the screen through the 2 layers of plastic and glasses and goggles.
Any one come across any good solutions for this type of problem. (another challenge -try to solder wires in a clean room wearing 2 pairs of rubber gloves.
Thanks,
Steve
The control cabinet and PLC are in the clean room.I had to wrap the laptop in 2 plastic bags .It then was cleaned with alcohol and left for 10 minutes in a pass through chamber.
Problems -the laptop heated up ,its not easy to see the screen through the 2 layers of plastic and glasses and goggles.
Any one come across any good solutions for this type of problem. (another challenge -try to solder wires in a clean room wearing 2 pairs of rubber gloves.
Thanks,
Steve