Zelio Logic Pause Timer

[Andrew EPS]

Hi there, I have a Zelio SR2B121JD and am trying to work out in FBD how to pause a timer. If I start a timer for a 60 second countdown, how can I pause it and resume again from the current value?

Any help would be appreciated! Thanks.

 

[osmanjdt]

try this

 

[jrwb4gbm]

Here is one possible solution. I used a counter to retain the value. At the end of the count the output turns on. When the Input (Starts Timing) is On and the Reset is Off, the "Counter as a Timer" is running. If the Reset input is On, the counter resets to Zero and is held at Zero until the Reset input is Off.

 

[Andrew EPS]

Hey thanks guys, that was really helpful. I think the counter will work in my circuit.

 

[rpili1313]

timer

Hi Guys,

I'm also looking for a timer but another function.

I'm using telerupter modules to switch my lights. But on 1 of them I would like to set a count down timer. So in other words it should, for example, go out after 2 hours.

I can not seem to find it myself so any help would be wonderful.

Thx
Rob

 

[Andrew EPS]

Rob, I think you just need a timing relay with an off delay.

 

[rpili1313]

Rob, I think you just need a timing relay with an off delay.

Could you give some more info about this?
Not really a pro in these kind of things.

Maybe schema or something?

 

[osmanjdt]

any info on the telerupter module/smart relay you using

 

[rpili1313]

any info on the telerupter module/smart relay you using

https://drive.google.com/file/d/0B9uZVD3d4d9FLVZETk1QcGR3N3c/view?usp=sharing

 

[osmanjdt]

you using macro?

 

[rpili1313]

Yes

 

[osmanjdt]

try this and please modified to meet your application

 

[rpili1313]

try this and please modified to meet your application

Just to understand correctly, I do not need to use my macro?

I have rebuild this but it doesn't work, the output it always ON.

 

[osmanjdt]

2nd test

 

[rpili1313]

2nd test

I think it will work. I had to make small adaption because I work with push buttons, the macro I already had, has to used in your schema.

I will try to upload the schema later this week to have a practical test.


The only disadvantage I have at the moment, my macro is not reset after the timer has done. So I have to push the button 2 the reactivate the output.