ControlsDude17
Supporting Member
Hello Everyone,
I am not proficient with STL so I wanted to get another opinion on this big of logic.
A(
L #MaxPos //maximum position [mm] greater than...
L DBD [AR1,P#2.0] //...absolute pane position [mm]...
>=D
)
A(
L DBD [AR1,P#2.0] //...absolute pane position [mm]...
L #MinPos //...and minimal position [mm]...
>=D //...less than absolute pane position [mm]...
)
JCN N1Lo
I read this as my DBD[AR1,P#2.0] both has to be Larger or equal to #MaxPos and Less than or equal to #MinPos in order to execute JCN N1Lo.
Is this correct or am I misreading this?
I am not proficient with STL so I wanted to get another opinion on this big of logic.
A(
L #MaxPos //maximum position [mm] greater than...
L DBD [AR1,P#2.0] //...absolute pane position [mm]...
>=D
)
A(
L DBD [AR1,P#2.0] //...absolute pane position [mm]...
L #MinPos //...and minimal position [mm]...
>=D //...less than absolute pane position [mm]...
)
JCN N1Lo
I read this as my DBD[AR1,P#2.0] both has to be Larger or equal to #MaxPos and Less than or equal to #MinPos in order to execute JCN N1Lo.
Is this correct or am I misreading this?