toddp65
Member
Siemens Tia Portal question.
Attached is the norm x and scale x blocks.
I'm an AB guy so I'm a little confused. I programmed these networks and they work. Both are for PSI transducers. Both report to Ignition and show the correct variable but with no decimal place even though I classified them as REAL and Floats in Ignition. The final out is not a FP. I'm confused with the method of scaling despite the fact the final number is correct.
Why is the output from the Norm a 0.6 number despite the fact the EU is 16xxx?
Why am I not getting a decimal place?
Thanks...
Attached is the norm x and scale x blocks.
I'm an AB guy so I'm a little confused. I programmed these networks and they work. Both are for PSI transducers. Both report to Ignition and show the correct variable but with no decimal place even though I classified them as REAL and Floats in Ignition. The final out is not a FP. I'm confused with the method of scaling despite the fact the final number is correct.
Why is the output from the Norm a 0.6 number despite the fact the EU is 16xxx?
Why am I not getting a decimal place?
Thanks...