MaGoOoDy
Member
i am struggling to alternate between two pumps in my lift station project. ( this is my first project so far )
whenever i test the whole program and it is almost complete only i have found a mistake in the part of alternating the pump, it is not as the control sequence said .
i have attached the part of the program where i program the lead/lag switching, when i toggle the ( 7 days cycle trigger ) then the program stuck in toggling loop.
this the pdf of the program
https://ufile.io/l4zab
this is recording of my screen when i run the program online.
https://ufile.io/fwz1q
do i am making this in proper way ?
guys, how do you handle this alternating ( lead/lag ) between part ?
attached the control philosophy
whenever i test the whole program and it is almost complete only i have found a mistake in the part of alternating the pump, it is not as the control sequence said .
i have attached the part of the program where i program the lead/lag switching, when i toggle the ( 7 days cycle trigger ) then the program stuck in toggling loop.
this the pdf of the program
https://ufile.io/l4zab
this is recording of my screen when i run the program online.
https://ufile.io/fwz1q
do i am making this in proper way ?
guys, how do you handle this alternating ( lead/lag ) between part ?
attached the control philosophy