I have PV300 micro and i can not get it work in communication with my PC. I have cable 1761-CBL-PM02 SER. C.
These are the settings in RSlinx:
comm port:com 10
device:slc-ch0/Micro/panelview
baud rate:19200(it is same on PV300 micro)
station nmbr:00
Parity:none
Error checking:CRC
Stop bits:1
Protocol:Full duplex
When i go to automatic configure it says: "Unable to verify settings due to packet timeout! Check all cables and configuration and try again."
I use USB to serial cable that creates COM 10, dippends on which USB hub i use but i think that this doesn't matter.
So could anybody help me with this problem PLEASE!!!
These are the settings in RSlinx:
comm port:com 10
device:slc-ch0/Micro/panelview
baud rate:19200(it is same on PV300 micro)
station nmbr:00
Parity:none
Error checking:CRC
Stop bits:1
Protocol:Full duplex
When i go to automatic configure it says: "Unable to verify settings due to packet timeout! Check all cables and configuration and try again."
I use USB to serial cable that creates COM 10, dippends on which USB hub i use but i think that this doesn't matter.
So could anybody help me with this problem PLEASE!!!