jguidotti
Member
Hi, I am for the first time setting up a Control Logix Gateway to allow me to communicate with a PLC5/40, and another Control Logix processor via a laptop (using Ethernet). My new hardware is as follows,
4 slot chassis
Power supply
DH+/RIO module
EtherNet IP module
I have read through some manuals and I am lead to believe that I need to download the Control Logix Gateway Configuration software 1756-GTWY, is that a requirement?
As I mentioned I am all read out, is there a simple method to configure this setup? Any assistance or detail would be greatly appreciated.
Thanks James
4 slot chassis
Power supply
DH+/RIO module
EtherNet IP module
I have read through some manuals and I am lead to believe that I need to download the Control Logix Gateway Configuration software 1756-GTWY, is that a requirement?
As I mentioned I am all read out, is there a simple method to configure this setup? Any assistance or detail would be greatly appreciated.
Thanks James