I am writing a program for Twido CPU using twido suite ver. 2.30 to control 10 vfd using Magelis HMI, VFDs are controlled by Macro Drives.
The problem is Executable memory usage goes 105% for the controller (TWDLCAA24DRF) when programmed for 10 vfd but if I delete configuration for one VFD than memory usage comes to 95%, Used Memory words are from %MW0 to %MW299 for Macro Drives and from %MW300 to %MW352 for other (not all used).
When Compiled it gives error of too much memory used and so cannot transfer to PLC even with 95% memory usage
If anyone figure out whats wrong and how it can be corrected than I can send a project file.
Thank you
The problem is Executable memory usage goes 105% for the controller (TWDLCAA24DRF) when programmed for 10 vfd but if I delete configuration for one VFD than memory usage comes to 95%, Used Memory words are from %MW0 to %MW299 for Macro Drives and from %MW300 to %MW352 for other (not all used).
When Compiled it gives error of too much memory used and so cannot transfer to PLC even with 95% memory usage
If anyone figure out whats wrong and how it can be corrected than I can send a project file.
Thank you
Last edited: