dana123
Member
Hello,
I was wondering if I could ask a question about programming....
I am VERY new to writing PLC but not troubleshooting. Anyway, I am trying to learn on a Micrologix 1000, using a PC and RSLogix 500.
I want to write a program to count up binary, on about 5 lights, using as an input a toggle switch.It should be a simple program, but I cannot get past a small problem. When I throw the switch, it keeps counting. I only want 1 pulse with the switch up, so it counts up slowly. I need to like de-bounce the switch, sort of. Any ideas???
Thanks,
Dana
I was wondering if I could ask a question about programming....
I am VERY new to writing PLC but not troubleshooting. Anyway, I am trying to learn on a Micrologix 1000, using a PC and RSLogix 500.
I want to write a program to count up binary, on about 5 lights, using as an input a toggle switch.It should be a simple program, but I cannot get past a small problem. When I throw the switch, it keeps counting. I only want 1 pulse with the switch up, so it counts up slowly. I need to like de-bounce the switch, sort of. Any ideas???
Thanks,
Dana