ABB/Entrelec Terminals

Old No. 7

Member
O
Join Date
Jun 2010
Location
Ohio
Posts
173
A little off topic here, but...

Does anyone use Entrelec terminal test adapters (DCO and DCJ)? If so does anyone stock them? I've searched all over and it seems like everyone has a 7-8 week delivery on something you would think are made by the tens of thousands.

I also have some concern about the DCO's not fitting the terminals we use properly as we've had some not fit right even though the catalog says they are the right ones.
 

Similar Topics

T
ABB PM554-T
Quick question: Can PLC ABB PM554-T generate PWM/PTO for controlling servo drive? Can not find manual file.
Replies
1
Views
38
DarrylR
D
R
Unable to import capability file for FF device in ABB Freelance engineering tool
Recently we have purchased the Rosemount 752 remote indicator to replace with new one, Capability file for that FF Device is unable to import with...
Replies
0
Views
46
Rehanuldhanveer
R
EICS
ABB PS501 Control Builder Plus V2.3 Install - anyone use it or know of it
does anyone have an install or know if/where i can download it for the following "ABB PS501 Control Builder Plus V2.3 " the software was a free...
Replies
2
Views
135
ojz0r
O
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
181
kamenges
K
R
ABB ACS800-07 VSD fault on ramp up between 98 and 100%
Hi hoping someone can assist me with current issue I am experiencing with an ABB drive. Problem I’m experiencing is a ABB drive supply a large...
Replies
4
Views
241
BryanG
B
Back
Top Bottom